Evolution Powersports baseline dyno tested the 181 crank HP PRO XP on their Dynojet chassis dyno at 148 - 150 WHP all stock which translates to about a 18% drivetrain loss. They installed our EVP Performance ECU software calibration to improve overall power of the engine on pump 91 octane fuel and gained a tremendous power improvement over stock. The EVP software tune alone unlocked an additional ~13 whp from this 925CC Polaris Prostar engine on 91 octane fuel with stock exhaust. Additionally, the cooling fans are triggered 15 degrees cooler, the rev limits and speed limits are raised and the ignition and fuel tables are calibrated for optimal power. Additional improvements are achieved with our exhaust upgrade and Stage 2 (91 Octane) software at ~167 WHP. Our Stage 3R (93 octane) delivers ~178 WHP.
Stage 4R (95 Octane) & Stage 5R (E85) tunes are in development.
Stage 1 ECU Upgrade 91 Octane (Stock Exhaust): ~163 WHP / ~ 198 HP
Stage 2 ECU Upgrade 91 Octane (Slip On Exhaust): ~167 WHP / ~204 HP
Stage 3 ECU Upgrade 93 Octane (Slip On Exhaust): ~178 WHP / ~218 H
Polaris PRO XP ECU Programming – Standard Tune Features:
- Diagnostic Port flash -meaning your ECU does not have to be opened!*
- Different stages of software depending on exhaust upgrades and fuel octane
- Rev limits raised to 9300
- Speed limit raised to 120 MPH
- Left foot braking enabled (gas and brake at the same time without going into limp mode)
- Fan on temps lowered (for a cooler running engine)
- Boost, Fueling and Ignition Optimized / More aggressive throttle / TQ limits removed
*On Mail order ECU’s, our bench flash procedures does not require opening of the ECU.
The factory seal is retained
Please send ECU to:
1725 W Williams Dr
STE 65
Phoenix, AZ 85027
